3.7M Intelligent 140W Motor Parking Advertising Barriers With Loop
|Length of boom arm||Customized depend on demands|
|Arm plate number||Depends on the boom length|
|Advertising plate size||82x830mm|
|Screen size boxes||450x880mm|
|LED light power||16.7A,200 W|
|Barrier height after the lift||Depending on the arm length|
|Working speed||Generally for 5 seconds(Special requirements can be customized)|
|The arm center height||1050mm|
|Input interface||+12 Level signal or pulse signal is greater than 100ms,the derive
current of less than 10mA|
Advertising Barrier Features
1.1 Advertising barrier’s house is durable and water-proof, so it
can be used outdoor.
1. 2 Appearance is simple and generous with advertising lamp house
And advertising board. Advertising board can be dismantled, and
easy to change advertising photo, All operation is simple.
1.3 Both barrier housing and arm plate are equipped with LED
lights, the LED lights can be controller via timer(it can be set
like this: close in day time and open at night).
1.4. Adopt multiple protective measures (like anti-wind, preventing
motor overheat, Anti-surge, Thunder-proof and so on),which increase
barrier’s safety and reliability.
1.5. Add loop sensor, following functions can be realized: auto
close, auto bounce up etc.It can automatic closing gate and perfect
preventing smashing car.
1.6. System adopts standard electric interface which can connect
with other system easily.
Advertising Barrier Installation Instruction
1. Install main arm: After fixed barrier housing, insert main arm
into arm holder, and fix it via M10*90 screw, and then insert LED
light wire into housing via main shaft.
2. Fix connect rod parts: Using M5*20m screws and butterfly nuts to
fix connecting rod on housing holes.
3. Fix small arm on connect rod: Using M8*70 screws to connect rod
with small arm, and fix connect rod.
4 .Install poles: First use stays webs make stays to connect, and
M5*20 screws lock; then use stays’ connecting axis across main and
sub-boom arm, finally use lock-nut to lock
5. Install advertising plate: Insert the plate into arm groove
(notice: arrow face down). And use screws to lock cover.
6.Debugging: After finished arm assemble, use handle to open and
close the barrier. After checking everything is ok, connect power
Parameters of Advertising Barrier Controller
3.1. Remote controller handle or wire controller to open, close and
3.2. 5V power rising, closing arm reach connector
3.3. Infrared and pressure sensor interface (anti-crash interface).
3.4. Anti-crash and auto close function (loop detector connector).
3.5. Prevent blocking.
3.6. Traffic lights interfaces.
3.7. After fallen boom arm in place, then connected output